To get in home wifi connect a wireless router to your free spectrum internet modem.
Spectrum wifi modem setup.
Follow these simple steps to hook up your spectrum modem and router.
How to install a new spectrum modem router plug the modem into the power outlet in the wall.
You should see your.
Plug the ethernet cable into the back of your computer on one end and into the modem s ethernet port on the other end.
Connect one end of the included coax cable to the modem and the other end to a cable outlet.
Setup the new router.
Wait for the wifi light on the front panel of the wifi router to turn on.
Type http 192 168 0 1 in your browser bar while connected to your wifi enabled internet modem either directly or via wifi.
Connect one of the power cables to the modem and wait while it connects.
Sign up for an optimized high performance spectrum wifi router covered by 24x7 tech support.
Next you should review the password for your wi fi network to make sure it s strong and secure.
Connect one end of the spectrum receiver s coax cable to one of the out connectors on the splitter.
If you already own a compatible router you can connect it but top speeds and security aren t guaranteed.
Plug the power cord into the wifi router and then plug the other end into an electrical outlet.
When you re on the go you can enjoy unlimited free access to more than 500 000 spectrum wifi hotspots from coast to coast.
Enter the username and passcode to get into the settings of your wifi enabled internet modem.
Connect one end of the long coax cable to the other out connector on the splitter and the other end to the modem.
This can take up to five minutes.
Continue setup at step 2.
Attach the coaxial cable to the wall jack on one in and the other to the port on the modem.
We re sorry this browser is no longer supported.
We re sorry this browser is.
At home it s easy to add spectrum wifi and connect in any room.
Connect one end of the ethernet cable to the modem and the other end to the yellow internet port on the wifi router.
To do this look for a wireless or wi fi section in the router s firmware.
Make sure the other end is connected to your spectrum receiver.
Under the lan settings change nat mode to bridged mode and save it.
